General International 25-200 M1 Manuel d'utilisation et d'entretien télécharger pdf (Page 6)

UNPACKING & SET UP

UNPACKING

LIST OF CONTENTS

Once the parts have been removed from the

packaging, you should have the following items:

Qty

A- TOOL REST LOCKING LEVER . . . . . . . . . . . . . . . . . . . .1

B- TOOL REST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

C- HEADSTOCK SPUR CENTER . . . . . . . . . . . . . . . . . . . . .1

D- TAILSTOCK LIVE CENTER . . . . . . . . . . . . . . . . . . . . . . .1

E- TOOL REST EXTENSION POST . . . . . . . . . . . . . . . . . . . .1

F- KNOCK OUT BAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

G- OUTBOARD EXTENSION HARDWARE . . . . . . . . . . . . . .2

H- SAFETY GLASSES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

I- OUTBOARD BED EXTENSION . . . . . . . . . . . . . . . . . . . .1

J- BELT TENSION LEVER . . . . . . . . . . . . . . . . . . . . . . . . . .1

K- LEVELING FEET (with nuts) . . . . . . . . . . . . . . . . . . . . . .4

L- FACE PLATE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

M- FACE PLATE WRENCH . . . . . . . . . . . . . . . . . . . . . . . . . .1

N- ALLEN KEYS (3 MM AND 6 MM) . . . . . . . . . . . . . . . . .1

O- LATHE WITH HEADSTOCK, TAILSTOCK AND TOOL

REST CARRIAGE (NOT SHOWN) . . . . . . . . . . . . . . . . .1

CLEAN UP

The unpainted cast-iron surface of the lathe bed is covered with a protective coating that helps prevent rust from

forming during shipping and storage. Remove this protective coating by rubbing with a rag dipped in kerosene,

mineral spirits or paint thinner. (Handle and dispose of potentially flammable solvent soaked rags according to

manufacturers’ safety recommendations.)

A putty knife held flat to avoid scratching the surface, may also be used to scrape off the coating followed by

clean-up with solvent. Avoid rubbing the lathes painted surfaces as many solvent based products will remove paint.

To prevent rust, apply a light coating of paste wax or use regular applications of any after-market surface protec-

tant or rust inhibitor.

Be sure to work in a well ventilated area for the clean-up process.

Carefully unpack and remove the wood lathe and its components from the box and check for damaged or miss-

ing items as per the list of contents below.

NOTE: Please report any damaged or missing items to your General International distributor immediately.

This model 25-200 is heavy – 146 lbs (66.5 kg). Do not over-exert. The help of an assistant will be needed for the fol-

lowing step.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

General International 25-200 M1 Manuel d'utilisation et d'entretien Page 6