General International 25-114QC M1 Manuel d'utilisation et d'entretien télécharger pdf (Page 13)

The tool rest carriage can be moved along the bed

slide ways as needed. Loosen the tool rest carriage

lever A and move the carriage to the desired location.

Re-tighten the lever securely after adjustment.

The tool rest should be adjusted so that its top is 1/8"

above the center of the workpiece. Loosen the tool rest

locking lever B and adjust the height and position of

the tool rest as needed. Re-tighten the lever securely

after adjustment.

TOOL REST CARRIAGE & TOOL REST ADJUSTMENTS

The headstock spindle has an MT#2 taper hole A into

which the spur center fits.

1. Unlock the face plate by loosening and removing

the two set screws B using a 3 mm Allen key.

4. Make sure the shank of the spur center E and the

spindle hole are clean and free of debris, and

then fit the spur center firmly in the spindle hole by

hand F.

MOUNTING & REMOVING THE HEADSTOCK SPUR CENTER

To remove the headstock spur center: knock it out

from the opposite end of the spindle, using the sup-

plied knock-out-bar G.

Note: When knocking out the spur center, always hold it by

hand to prevent it from falling.

2. Loosen the face plate by inserting the supplied

knock out bar in the spindle hole to keep the

spindle from turning while loosening the face

plate using the supplied face plate wrench, as

shown in C.

3. Unscrew and remove the face plate, D.

TOP VIEW

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Pas de commentaire

General International 25-114QC M1 Manuel d'utilisation et d'entretien Page 13