General International 25-114QC M1 Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

CLEAN UP

The unpainted cast-iron surface of the lathe bed is covered with a protective coating that helps prevent rust from

forming during shipping and storage. Remove this protective coating by rubbing with a rag dipped in kerosene,

mineral spirits or paint thinner. (Handle and dispose of potentially flammable solvent soaked rags according to

manufacturers’ safety recommendations.) A putty knife held flat to avoid scratching the surface, may also be used

to scrape off the coating followed by clean-up with solvent. Avoid rubbing the lathes painted surfaces as many sol-

vent based products will remove paint.

To prevent rust, apply a light coating of paste wax or use regular applications of any after-market surface protec-

tant or rust inhibitor.

INSTALLATION & ASSEMBLY

For your convenience this lathe is shipped from the factory partially assembled and requires only minimal assem-

bly and set-up before being put into service.

SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COM-

PLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED

TO DO SO.

1. If the lathe is not to be used with an optional stand,

install the leveling feet A and set the lathe on your

workbench.

Note: If you prefer an optional steel stand (item 25-195) is

available from your local General International dealer.

The stand is equipped with mounting holes allowing the

lathe to be bolted directly to the stand (hardware not

included.

The unit should be installed on a flat, sturdy and stable

surface able to support the weight of the machine and

the workpiece with ease.

Never install the lathe over

the edge of a table or work-

bench.

FOR YOUR SAFETY IT IS ESSENTIAL THAT THE MACHINE DOES NOT ROCK OR TIP DURING OPERATION. UPON START-UP OR DURING

OPERATION, IF YOU NOTICE ANY ROCKING, TIPPING OR CHATTERING OF THE BASE TURN THE MACHINE OFF IMMEDIATELY AND

READJUST THE LEVELING FEET AS NEEDED TO STABILIZE THE LATHE ON THE BENCH.

Note: If a permanent shop placement is practical, consid-

er removing the leveling feet on the base and drilling

matching through-holes in the mounting surface of your

workbench to bolt the lathe in place on your workbench

(hardware not included).

2. Adjust the leveling feet to ensure that all four feet sit

firmly on the bench. Make sure that the machine

does not rock.

a.Lathe

b.Workbench

c.Flat washer

d.Lock washer

e.Hex head bolt

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

General International 25-114QC M1 Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Tours General International 25-114QC M1