General International 25-114QC M1 Manuel d'utilisation et d'entretien télécharger pdf (Page 14)

The tailstock has an MT#2 taper hole into which the live

center fits.

1. Make sure the shank of the live center and the tail-

stock hole are clean and free of debris and fit the

live center firmly in the spindle hole by hand H.

o r

emove the live center from the tailstock quill:

loosen the tailstock quill locking lever I and move the

quill out by turning the quill movement hand wheel J

until the quill end is nearly inside the tailstock and the

live center can be removed by hand.

Note: When removing the live center, always hold it by

hand to prevent it from falling

MOUNTING & REMOVING THE TAILSTOCK LIVE CENTER

The tailstock quill can be moved in and out of the tail-

stock casting L by turning the tailstock quill movement

hand wheel M.

1. To move the tailstock quill, loosen the quill locking

lever N.

2. Turn the the quill movement hand wheel to move

the quill as needed.

3. Re-tighten the quill locking lever to secure the quill

in position.

MOVING T

AILSTOCK QUILL IN / OUT

TAILSTOCK REAR VIEW

The tailstock is used to support the other end of the

workpiece to be turned and can be moved along the

bed slideways to suit the length of the workpiece O.To

move the tailstock on the bed:

1. Loosen the tailstock locking lever P.

2. Move the tailstock by hand to the desired location

on the bed.

3. Retighten the tailstock locking lever to secure the

tailstock in position.

TAILSTOCK MOVEMENT

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

General International 25-114QC M1 Manuel d'utilisation et d'entretien Page 14